Jeep compass 2017, Руководство пользователя

Страница: 16 / 332

All doors can be programmed to unlock
on the first push of the unlock button.
Refer to “Uconnect Settings” in “Multi-
media”
in your Owner’s Manual at
www.jeep.com/en/owners/manuals/ for fur-
ther information.
To Lock The Doors And Liftgate
Push and release the lock button on the key
fob to lock all doors and liftgate.
Request For Additional Key Fobs
NOTE:
Only key fobs that are programmed to the
vehicle electronics can be used to start and
operate the vehicle. Once a key fob is pro-
grammed to a vehicle, it cannot be pro-
grammed to any other vehicle.
WARNING!
• Always remove the key fobs from the
vehicle and lock all doors when leaving
the vehicle unattended.
• For vehicles equipped with Keyless Go
— Ignition, always remember to place
the ignition in the OFF mode.
Duplication of key fobs may be performed at
your authorized dealer. This procedure con-
sists of programming a blank key fob to the
vehicle electronics. A blank key fob is one
that has never been programmed.
NOTE:
When having the Sentry Key Immobilizer Sys-
tem serviced, bring all vehicle keys with you
to your authorized dealer.
IGNITION SWITCH
Keyless Go — Ignition
This feature allows the driver to operate the
ignition with the push of a button as long as
the key fob is in the passenger compartment.
The START/STOP push button ignition has
three operating modes. The three modes are
OFF, ON/RUN, and START.
NOTE:
If the ignition state/mode does not change
with the push of a button, the key fob may
have a low or dead battery. In this situation, a
back up method can be used to operate the
ignition switch. Put the nose side (side oppo-
site of the emergency key) of the key fob
against the ENGINE START/STOP button and
push to operate the ignition.
The push button ignition can be placed in the
following modes:
OFF
• The engine is stopped.
START/STOP Ignition Button
GETTING
TO
KNOW
YOUR
VEHICLE
14