Jeep 2015 Wrangler, Руководство по эксплуатации

Страница: 73 / 750

Answer Or Reject An Incoming Call —
Call Currently In Progress
If a call is currently in progress and you have
another incoming call, you will hear the same
network tones for call waiting that you normally
hear when using your mobile phone. Push the
button to place the current call on hold and
answer the incoming call.
NOTE:
The Uconnect® Phone compatible phones
in the market today do not support rejecting
an incoming call when another call is in
progress. Therefore, the user can only an-
swer an incoming call or ignore it.
Making A Second Call While Current Call In
Progress
To make a second call while you are currently
on a call, push the
button and say “Dial” or
“Call” followed by the phone number or phone-
book entry you wish to call. The first call will be
on hold while the second call is in progress.
To go back to the first call, refer to “Toggling
Between Calls.” To combine two calls, refer to
“Conference Call.”
Place/Retrieve A Call From Hold
To put a call on hold, push the
button until
you hear a single beep. This indicates that the
call is on hold. To bring the call back from hold,
push and hold the
button until you hear a
single beep.
Toggling Between Calls
If two calls are in progress (one active and one
on hold), push the
button until you hear a
single beep, indicating that the active and hold
status of the two calls have switched. Only one
call can be placed on hold at one time.
Conference Call
When two calls are in progress (one active and
one on hold), push and hold the
button until
you hear a double beep indicating that the two
calls have been joined into one conference call.
Three-Way Calling
To initiate three-way calling, push the
but-
ton while a call is in progress, and make a
second phone call, as described under “Making
a Second Call While Current Call in Progress.”
After the second call has established, push and
hold the
button until you hear a double beep,
indicating that the two calls have been joined
into one conference call.
Call Termination
To end a call in progress, momentarily push the
button. Only the active call(s) will be termi-
nated and if there is a call on hold, it will become
the new active call. If the active call is termi-
nated by the phone far end, a call on hold may
not become active automatically. This is cell
phone-dependent. To bring the call back from
hold, push and hold the
button until you hear
a single beep.
Redial
•
Push the button to begin.
•
After the “Ready” prompt and the following
beep, say “Redial.”
•
The Uconnect® Phone will call the last num-
ber that was dialed from your mobile phone.
NOTE:
This may not be the last number dialed from
the Uconnect® Phone.
70