Jeep 2015 Wrangler, Руководство по эксплуатации

Страница: 330 / 750

Fluid Level Check
Check the fluid level by removing the fill plug.
The fluid level should be between the bottom of
the fill hole and a point not more than 3/16 in
(4.76 mm) below the bottom of the hole.
Add fluid, if necessary, to maintain the proper
level.
Frequency Of Fluid Change
Under normal operating conditions, the fluid
installed at the factory will give satisfactory
lubrication for the life of the vehicle. If the fluid
becomes contaminated with water, it should be
changed immediately. Otherwise, change the
fluid as recommended in the Service And War-
ranty Handbook. Refer to the “Service And
Warranty Handbook” for the proper mainte-
nance intervals.
Transfer Case
Fluid Level Check
The fluid level should be to the bottom edge of
the fill hole (A) when the vehicle is in a level
position.
Adding Fluid
Fluid should be added only at filler hole until
fluid begins to run out of the hole.
Drain
First remove the fill plug (B), then the drain plug
(C). The recommended tightening torque for the
drain and fill plugs is 15 to 25 ft lbs (20 to 34 N·m).
CAUTION!
When replacing the plugs, do not overtighten
them. You could damage them and cause
them to leak.
Selection Of Lubricant
Use only manufacturer’s recommended fluid.
Refer to “Fluids, Lubricants, and Genuine Parts”
in “Maintaining Your Vehicle” for further informa-
tion.
Front/Rear Axle Fluid
For normal service, periodic fluid level checks
are not required. When the vehicle is serviced
for other reasons the exterior surfaces of the
axle assembly should be inspected. If gear oil
leakage is suspected inspect the fluid level.
Refer to “Fluids, Lubricants, and Genuine Parts”
in “Maintaining Your Vehicle” for further informa-
tion.
Fluid Level Check
Lubricant should be at the bottom edge of the oil
fill hole.
Adding Fluid
Add lubricant only at the fill hole and only to the
level specified above.
Transfer case
327