Jeep 2013 Grand Cherokee, Руководство по эксплуатации

Страница: 61 / 408

Installing a Child Restraint with an ALR:
1. To install a child restraint with ALR, first, pull
enough of the seat belt webbing from the retrac-
tor to route it through the belt path of the child
restraint. Slide the latch plate into the buckle
until you hear a “click.” Next, extract all the seat
belt webbing out of the retractor and then allow
the belt to retract into the retractor. As the belt
retracts, you will hear a ratcheting sound. This
indicates the safety belt is now in the Automatic
Locking mode.
2. Finally, pull on any excess webbing to
tighten the lap portion around the child restraint.
Any seat belt system will loosen with time, so
check the belt occasionally, and pull it tight if
necessary.
To attach a child restraint tether strap:
For rearward facing infant seats secured in the
center seat position with the vehicle seat belts,
the rear center seat position has an armrest
tether that secures the arm rest in the upward
position. To access the center seat arm rest
tether first lower the arm rest. The tether is
located behind the armrest and hooked onto the
plastic seat backing.
Pull down on the tether to unhook it from the
plastic seat backing, then raise the armrest and
attach the tether hook to the strap located on
the front of the arm rest.
For center seating position route the tether
strap over the seatback and headrest then
attach the hook to the tether anchor located on
the back of the outboard seats. For the out-
board seating positions, route the tether under
Center Seat Position Arm Rest Tether
Center Seat Position Arm Rest Tether Attached
57