Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you keep
the good numbering when you turn the pages of the I/B.
Don’t change the page numbering. Keep the language
integrity.
8
170407
Assembly page 8/16
Fax +32 2 359 95 50
IMPORTANT INFORMATION
This appliance is not intended for professional use. You should follow the requested breaks.
Failure to follow this instruction carefully may result in damage to the motor. Please refer to the
rating label for the maximum continuous usage time (KB xx min where xx is the allowed
maximum usage time). The breaks should last at least 10 minutes.
SET UP YOUR STAND MIXER AND OPERATE FOR THE FIRST TIME
Please unpack the stand mixer from the gift box and remove all product packaging from
within.
To raise the mixing arm press the ‘TILT’ button which is located next to the on/off speed
dial, and lift the mixing arm slowly with one hand on top of the mixing arm.
All of the mixing attachments can be found within the mixing bowl. Please remove all
attachments from the mixing bowl. The splash guard must be removed by holding it firmly
with both hands and turning it in an anticlockwise direction. This will bring the splash guard
free from the mixing arm. Please note that the splash guard may be stiff at first but will
loosen after repeated use.
To remove the mixing bowl, twist the mixing bowl anticlockwise using both hands and lift
free from the mixing bowl lock.
Use a clean damp cloth to wipe over the base unit before you use the Stand Mixer for the
first time.
All attachments as well as the mixing bowl and splash guard need to be washed using
warm soapy water before being used. Please ensure all attachments are dried well before
use.
All parts must be clean and dry before the product is put together and used.
Warning: The plug of the stand mixer must not be inserted into a wall socket and turned on
until all parts have been fully assembled.
The base of the stand mixer must be situated on a flat area near a wall socket with all
walls and other surfaces at least 10cm away. This will ensure that the Stand Mixer has
sufficient airflow.
Before any of the attachments, mixing bowl or splash guard can be removed or added
the mixing arm must be raised using the ‘TILT’ button. Make sure to press the ‘TILT’ button
each time you wish to raise the mixing arm.
Attaching the mixing bowl
To attach the mixing bowl insert the mixing bowl into the mixing bowl lock ensuring that
the tabs found at the bottom of the mixing bowl line up with the notches in the mixing
bowl lock. Once inserted turn the mixing bowl using both hands and twist in a clockwise
direction using the ‘Lock’ arrow as a guide until the bowl is firmly in place.
Attaching the splash guard
The splash guard is best used when mixing with liquids and ingredients such as flour to
prevent dust escaping and splatters of liquid.
Position the splash guard into the splash guard lock. Using both hands align the arrow on
the splash guard with the unlock symbol which can be found on the mixing arm. Once in
place turn the splash guard clockwise until the arrow is aligned with the lock symbol and is
firmly in place.
Fitting the attachments
Please select which attachment you wish to use. Underneath each attachment there are
two notches which need to be aligned with the tabs found on the tool shaft.
Once aligned push the attachment up over the notches, once in place turn the
attachment in an anticlockwise direction, which will lock the attachment in place.
