Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you keep
the good numbering when you turn the pages of the I/B.
Don’t change the page numbering. Keep the language
integrity.
9
170407
Assembly page 9/16
Fax +32 2 359 95 50
Please ensure the attachment is locked and in place before use.
To move the mixing arm into position press the ‘TILT’ button and using your other hand
push the mixing arm down until the ‘TILT’ button clicks fully out. The splash guard should fit
securely over the bowl.
Removing the attachments
To remove the attachment push the attachment upwards towards the tool shaft and then
turn in a clockwise direction to release.
INSTRUCTIONS FOR USE
The Stand Mixer is fully interlocked for safety, it won’t switch on unless the mixing arm is tilted
downwards.
Check the speed dial is in the ‘0/OFF’ position.
Plug in and switch on the stand mixer at the socket.
The light around the speed dial will blink.
Press the ‘TILT’ button to raise the mixing arm into the upwards position. Add your
ingredients into the mixing bowl.
Do not operate the appliance when empty. The maximum working capacity is 2 litres
(2kg), or 1.2 litres (1.2kg) for heavier ingredients such as flour and water, or dough.
Press the ‘TILT’ button to lower the mixing arm into the downwards position, the ‘TILT’
button will click fully out.
When you switch on the stand mixer for the first time there may be a slight burning smell,
this is normal for a new appliance and will stop after a few uses.
To start mixing, twist the speed dial clockwise. Move slowly through the speeds to the
speed you require, the light around the speed dial will be solid when the appliance is
mixing.
DO NOT put your hands or utensils inside the mixing bowl while the stand mixer is on. If
adding food to the mixing bowl while the stand mixer is on, twist the speed dial to ‘0/off’
first. If you are using the splash guard, add food through the feed spout, pulse the stand
mixer if the attachment is blocking the feed spout.
If you need to scrape down food from the sides of the mixing bowl, switch off the
appliance and use a spatula.
Always switch off and unplug the appliance before you attach or remove any of the
attachments.
Do not operate the stand mixer continuously for more than 6 minutes. Allow the motor to
rest for 15 minutes between each use. Most mixing tasks will take around 3 minutes.
To stop the stand mixer, twist the speed dial back to ‘0/OFF’. The stand mixer will continue
to rotate for a few seconds after being switched off. Wait until it has fully stopped before
pressing the ‘TILT’ button to raise the arm and remove the bowl.
A GUIDE TO SPEED SETTINGS
The stand mixer has six different speed settings and also has an additional pulse setting which
can all be used for a number of different functions including mixing, kneading, whipping and
folding of various ingredients to make the perfect breads, cakes and biscuits.
When you first begin to mix ingredients start on the ‘1’ setting, if required turn the speed dial in
a clockwise direction to increase the speed in small increments up to the ‘6’ setting if required.
Please find below a simple guide for each attachment and which speeds we recommend
using for each attachment.
