Table of Contents
•
Introduction ……………………………………………………… 3
•
Installation Procedures…………………………………………. 4
•
Troubleshooting………………………………………………….6
•
FCC Statement…………………………………………………..7
•
Specifications…………………………………………………… 8
FCC Statement
PLEASE NOTE
: It is normal for your booster to be quite warm while in use.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help
.
RF Exposure Requirements:
The antenna used for the transmitter must not be connected to, or operating in conjunction with any other antenna
or transmitter.
Vehicle Antenna Installation:
- The Antennas used for this transmitter must not exceed 3dBi of gain with a minimum cable loss of 2.9dB.
- For vehicle antenna placement, the antenna must be located at least 20cm away from the rear-seat passengers
and by standers in order to comply with the FCC RF exposure requirements.
Failure to observe these requirements will result in exceeding the FCC RF exposure limits.
2
7
