JDS Uniphase RX3 Series, Руководство пользователя

Страница: 22 / 55

9
Figure 6: Connector Cleaning (connector type can vary)
2. Apply optical grade isopropyl alcohol or optical grade ethanol (do not use rubbing alcohol) to
a small area of a lint-free towel and rub the end of the ferrule over the wet area.
3. Wipe the ferrule on a dry area of the lint-free towel.
4. Using the dusting gas or compressed air, blow the end of the ferrule.
5. Apply the alcohol or ethanol to a lint-free pipe cleaner or swab and wipe off the remaining
parts of the connector.
6. With the other end of the pipe cleaner or swab, dry the areas cleaned.
7. Using the dusting gas or compressed air, blow the areas cleaned.
Powering Up the Meter
To power up the meter:
1. Connect the meter to a power source, using the AC power cord provided.
2. Set the power switch to
I (on), and observe the power-up sequence. The prompt to restore
last settings or initialize the meter is displayed. The software version is displayed also.
Internal measurements of P
in
and P
dark
are made at both wavelengths
3. Select the Restore Last Settings or Initialize option (using the soft key to the right of the
option).
When you select the Restore Last Settings option, the meter retains the operating mode, source
and output setting, and all stored parameters that were active when the meter was last powered
off. The value of the operating mode, and the source and channel setting are displayed.
When you select the Initialize option, the meter is set to the operating state shown in Table 4.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com