JDS Uniphase OneExpert DSL, Руководство пользователя

Страница: 27 / 120

Chapter 2 Quick Tour
Exploring the top panel
OneExpert DSL User’s Guide
April 2014 22052280, Revision 001
11
Exploring the top panel
The Copper connectors are located near the top panel.
The copper connectors are used for:
• Multimeter
–
AC volts
– DC volts
• TDR
• Opens (distance) and capacitance
• Balance
• Load coil detect
• POTS
Navigating the user interface
The user interface of the OneExpert DSL is designed to be intuitive and easy to use. The LCD is a
touchscreen that operates similar to a mobile device (such as an iPad or similar Android device),
where you swipe to go to the next page or zoom in/out with pinching or opening your fingers.Using
the interface, you can view test results, set up the OneExpert DSL, and configure test parameters.
Figure 5 OneExpert DSL top panel
CAUTION: INSTRUMENT DAMAGE
Connecting to circuits with voltage higher than 300V, compared to ground, may damage the
internal components. Connect only to circuits with less than 300V.
WARNING: ELECTRICAL SHOCK
Electrical shock may result in serious injury or death. Use care when connecting to telecommu-
nications circuits, to be sure that you do not come in contact with exposed conductors or power
mains. Connect TNV signals to TNV ports only.