SATURN CHAIR INSTRUCTION MANUAL
Adjusting Height/ Tilt of Chair – Hydraulic Ram
Reference: Figure 2 – Height and Tilt Adjustment (Hydraulic).
Arrow 1:
The Lever indicated by Arrow 1 is a foot pedal used for heightening of the chair. To operate the height adjustment
you should first check that the lever indicated by Arrow 2 is locked securely in place by turning it in a clockwise
direction. Once secure the chair can be raised to the desired position by continually pumping on Lever 1 using one
of your feet. It is important that you stop to pump the lever whenever you reach a position of resistance, inspect the
chair for obstruction and ensure you haven’t reached the maximum height.
Arrow 2:
Lever 2 enables you to release the chair and lower it to its home position. To lower the chair you should turn lever 2
in an Anti Clockwise direction until the chair starts to contract to its lowest position. Whilst performing this
operation ensure that the chair mechanism is free from obstruction and assist the lowering by holding the chair at the
grab rails. To Re-Raise the chair Lever 2 will need to be secured tight again by turning and locking it in the
clockwise direction.
Arrow 3:
Lever 3 enables you to adjust the movement of Lever 2 in order to ensure a gradual decline to the lowest position.
On first lowering the chair its is recommended that the operator releases Lever 2 gradually until a steady decline
speed is achieved (Chair should be Loaded.) When the desired speed has been achieved you should set the
adjustment Lever 3 to this position in order to stop over adjustment of Lever 2. JCM Seating set this lever on
leaving the factory using a weight limit of 40Kgs. If this proves unsuitable then the adjustment has been provided
for operator purposes.
IMPORTANT
Always ensure that the height mechanism is free from obstruction before operating this chair.
Never Over Adjust or Over Tighten Moving Parts!
Figure 2 – Height and Tilt Adjustment (Hydraulic).
Page 3
Arrow 2
Arrow 1
Arrow 3
CLOCKWISE
ANTI - CLOCKWISE