![background image](http://html1.mh-extra.com/html/jcm/ipro-100-sh2-rc/ipro-100-sh2-rc_operation-and-maintenance-manual_640203138.webp)
P/N 960-000164R_Rev. 3 {EDP #213631}
© 2018, JAPAN CASH MACHINE CO., LTD.
A - 4
Appendix A
iPRO-RC™ Series Banknote Recycler
Troubleshooting
iPRO-RC Recycler Unit Width and
Length Guide Replacement
Procedure
The iPRO-RC™ Width and Length Guides located
in the Recycler Unit need to be replaced by a
trained Engineer or Technician using the following
Procedures:
Length Guide Replacement
To replace the Length Guide in the Recycler Unit,
proceed as follows:
1. Use the supplied Key to unlock the Recycler Unit
Door (Figure A-1
a
) and open the Door.
2. Remove the four (4) Screws retaining the Length
Guide in place (Figure A-2
a
).
3. Lift the Length Guide upward, as indicated by
Graphic Arrow
A
in Figure A-2.
4. Slide the Length Guide in the direction indicated
by Graphic Arrow
B
, as shown in Figure A-2.
5. Lift the Length Guide upward again, as indicated
by Graphic Arrow
C
, and lift the Length Guide up
and off of the Recycler Unit Door.
6. Remove the two (2) Screws (Figure A-2
d
) from
the removed RC Length Guide.
7. Remove the L Guide Assist Strip (Figure A-2
e
)
and install the Length Guide replacement.
Length Guide Installation
To install a new Length Guide into the Recycler
Unit, proceed as follows:
1. Place the new Length Guide in the direction
indicated by Graphic
Arrow
A
in Figure A-3
a
.
2. Slide the Length Guide in the direction indicated
by Graphic Arrow
B
, and align it to the edge of
the RC Recycler Door (Figure A-3
a
).
3. Install the four (4) Length Guide Mounting
Screws (Figure A-3
b
) for re-assembly.
Figure A-1
Opening the Recycler Unit Door
a
Figure A-1
Opening the Recycler Unit Door
NOTE: Remove both RC1 (Figure A-
b
) and RC2 (Figure A-2
c
) Length
Guides during the same procedure.
NOTE: When installing the L Guide
Assist Sheet, be sure that convex
portions of the Length Guide fit into
the holes provided for them on the
right and the left sides of the L Guide
Assist Strip (Figure A-2
f
).
Figure A-2
b
c
d
e
f
C
A
B
Figure A-2
Length Guide Removal
NOTE: When installing the RC2
Length Guide (Figure A-3
c
), insert
the L Guide Assist Strip onto the Door
d
), to complete this
procedure.
Figure A-3
New Length Guide Installation 1
b
d
c
a
B
A
Figure A-3
New Length Guide Installation 1