JCM GLOBAL VEGA 100, Руководство по обучению обслуживанию, Страница: 7 / 24

Part No. 960-000165R_Rev. 1 © 2013, JCM American, Corporation
7
July, 2013 JCM Training Overview VEGA™ Banknote Acceptor
Lecture Notes
INSTALLATION
VEGA SH U
NIT
Perform the following steps to install a VEGA SH Unit into a Host Machine:
1. Mount the VEGA SH Unit in place without the Cash Box installed.
2. Bolt the bottom of the VEGA Frame
into place using four (4) M4 Hex-
nuts (See Figure 3
a
1
, a
2
, a
3
& a
4
).
3. Set the VEGA DIP Switches to On-
line Mode (Refer to "
DIP Switch
Settings
" on page 10 of this Guide).
4. Connect the VEGA Unit to the Host
Machine using the User supplied
harness.
5. Apply power to the VEGA Unit.
6. Activate the VEGA Unit normally,
and confirm that the LED lighting
sequence indicates an active idle mode Color pattern as set by DIP Switch selec-
tion.
VEGA SU/SD U
NIT
Perform the following steps to install a VEGA SU/SD Unit into a Host
Machine.
1. Set the VEGA DIP Switches to On-line Mode (Refer to " DIP Switch Settings " on
page 10 of this Guide).
2. Connect the VEGA to the Host Machine using a User supplied Harness.
3. Apply power to the VEGA Unit.
4. Activate the VEGA Unit normally, and confirm that the LED lighting sequence
indicates an active Idle Mode Color pattern as set by DIP Switch selection.
5. Turn the VEGA Unit's power OFF and disconnect the Harness between the
VEGA and the Host Machine.
Figure 3 M4 Nut and DIP Switch
Locations
b
a
1
a
2
a
3
a
4
NOTE: The bolt lengths are not
to extend more than 5mm up
from the ground plane.
NOTE: Refer to Figure 3b to
locate the DIP Switches on the
VEGA Unit.