JCM GLOBAL VEGA 100, Руководство по обучению обслуживанию, Страница: 10 / 24

Part No. 960-000165R_Rev. 1 © 2013, JCM American, Corporation
1 0
Lecture Notes
VEGA™ Banknote Acceptor JCM Training Overview July, 2013
DIP SWITCH SETTINGS
The VEGA Banknote Validator contains three (3) DIP Switch Blocks (i.e.,
DS1, DS2, and DS3). They are located in the center of the top of the Unit
approximately two (2) inches from the front of the Unit (Review Figure 2
h ).
• DIP Switch Block DS1 is used to select Test Mode, and to select the desired
Banknote Acceptance/Inhibit settings shown in Table 2.
• DIP Switch Block DS2 is used to select between the desired Communications
Interface Protocols shown in Table 3.
• DIP Switch Block DS3 selects between the RS232C and Pulse Interface Com-
munication Protocols shown in Table 4.
Table 4 DIP Switch Block 3 Settings
Switch
No.
Switch ON Switch OFF
1 RS232C Interface Pulse Interface
Table 2 DIP Switch Block 1 Settings
Switch
No.
Switch ON Switch OFF
1
Test Mode
Basic
Performance
2
Refer to the Related Country’s
Software Specification Sheet
3
4
5
6
7
8
DS1
Table 3 DIP Switch Block 2 Settings
Switch
No.
Switch ON Switch OFF
1
Refer to the Related Country’s
Software Specification Sheet
2
3
4
5
6
7
8
DS2
6 7 8 IF Setting
OFF OFF OFF ID-003 Serial (RS-232C)
OFF ON ON
ID-003 (Photo-Coupler
Isolation)
OFF ON OFF ccTalk (Non-Encrypted)
ON ON OFF ccTalk (Encrypted)
ON OFF ON
ccTalk (Simple
Checksum)
ON OFF OFF MDB
DS3
1 (ON)
2 (OFF)