P/N 960-100929R_Rev. 3 {EDP #148849}
© 2012, Japan CashMachine Co., Limited
4 - 1
Next-Generation Banknote Acceptor Unit
S e c t i o n 4
This section provides disassembly and reassembly
instructions for the iVIZION
®
Next-Generation
Banknote Acceptor Unit. This section contains the
following information:
•
Tool Requirements
•
Pusher Unit Timing Belt Removal
•
Home Position Sensor Board/Home Position
Sensor FFC & Interface Connector Board
Removals
•
RFID Module & RFID Harness Removals
•
Validation CPU & Controller CPU Board
Removals
•
USB FPC/Power FPC & Interface FPC Cable
Removals
•
Validation Unit Harness Removal
•
Interrupter Board Removal
•
Motor Unit Timing Belt Removal
•
Stacker Motor & Transport Motor Removals
•
Bezel Hold Chips A/B Removals
•
Sensor Transfer Board/CIS FFC/Transmissive
Light FFC & Upper UV FPC Sensor Removals
•
Validation Sensor Board Removal
•
Validation Sensor FPC Card Removal
•
CIS/Transmissive Light/Upper UV Sensor
Removals
•
CIS/CIS FPC/Lower UV Sensor & Lower UV
FFC Removals
•
Validation Unit Timing Belt Removal.
Tool Requirements
The following tools will be required to perform
iVIZION
®
disassembly and reassembly.
•
#1 & #2 Phillips Screw Driver
•
Set of Jewelers Phillips Screw Drivers
•
#T6 “TORX” Brand Torque Wrench Driver
•
#1 & #2 Torque Wrench Drivers
•
Motor Gear Assembly Pressure Bar
•
Pliers
•
Tweezers.
Pusher Unit Timing Belt Removal
To remove the Timing Belt proceed as follows:
1. Remove the Cash Box from the
iVIZION
®
Unit.
2. Open the Cash Box Door’s bottom access Door.
3. Remove the two (2) screws (See Figure 4-1 a
1
&
a
2
) retaining the Pusher Mechanism Unit to the
Cash Box.
4. While pulling upward on the Door Latch Stop-
pers (See Figure 4-2 a
1
& a
2
) of the Pusher
Mechanism Unit (See Figure 4-2 b), slide it for-
ward to remove the Pusher Mechanism Assembly
out of the Cash Box.
5. Remove the four (4) screws (See Figure 4-3 a
1
,
a
2,
a
3
& a
4
) retaining the Unit Cover in place
(See Figure 4-3 b), and remove the Unit Cover
from the Pusher Mechanism Assembly.
4 DISASSEMBLY/REASSEMBLY
Figure 4-1
Pusher Mechanism Screws Removal
a
1
a
2
Figure 4-2
Pusher Mechanism Removal
a
1
a
2
b
Figure 4-3
Pusher Mechanism Cover Removal
a
2
a
1
a
4
a
3
b
