JCM GLOBAL DBV Series, Руководство по интеграции

Страница: 16 / 50

P/N 960-000175R_Rev. A {EDP #233426} © 2014, JAPAN CASH MACHINE CO., LTD.
8
DBV
®
Series Banknote Validator (DBV-400) Integration Guide
3 INSTALLATION
This section provides installation and operating
instructions for the DBV-400 Banknote Validator
unit. The information within this section contains
the following features:
• Installation Procedure
• DIP Switch Configuration
Installation Procedure
The DBV-400 Frame Unit provides installation
holes for each surface.
E
NTIRE
U
NIT
I
NSTALLATION
Perform the following steps to install the DBV-400
Unit:
1. Place the DBV-400 Unit Frame cut outs
(See Figure 5 a
1
through a
4 and
b
1 &
b
2
) on to the
Thread Studs chassis.
2. Secure the rear side of the DBV-400 Frame to the
chassis with six (6) nuts.
DIP Switch Configurations
This section provides the denomination DIP Switch
Block 1 (DS1) and Block 2 (DS2) Settings for the
DBV-400 Unit.
NOTE: Refer to “Unit Dimensions” on
page 35 for each Bezel’s dimensions.
Figure 5 Thread Studs Location
50.8
84
116
a
1
a
2
a
3
a
4
b
1
b
2
Chassis Side
Reference Dimensions
Insertion Slot
Area (Open)
Table 8 DIP Switch Block 1 Settings
Switch
No.
Switch ON Switch OFF
1
VEND 1 INHIBIT VEND 1 ACCEPT
2
VEND 2 INHIBIT VEND 2 ACCEPT
3
VEND 3 INHIBIT VEND 3 ACCEPT
4
VEND 4 INHIBIT VEND 4 ACCEPT
5
VEND 5 INHIBIT VEND 5 ACCEPT
6
VEND 6 INHIBIT VEND 6 ACCEPT
7
VEND 7 INHIBIT VEND 7 ACCEPT
8
TEST MODE FUNCTION
Table 9 DIP Switch Block 2 Settings
Switch
No.
Switch ON Switch OFF
1
OFF OFF
2
OFF OFF
3
OFF OFF
4
OFF OFF
5
OFF OFF
6
OFF OFF
7
OFF OFF
8
OFF OFF
DS1DS1
DS2