jcb 8014 CTS, Руководство оператора

Страница: 93 / 208

Operation
Transporting the Machine
81 9821/6100-4 81
5. Slightly extend the boom and dipper for stability.
6. With the machine in low speed mode, track forward onto the ramp slowly and smoothly. Make sure the
bucket will not contact the transporter ramps when loading the machine.
7. Slowly drive the machine to the top of the ramps.
8. Lower the boom until the bucket contacts the transporter deck.
9. Slowly drive forward. As the tracks begin to clear the ramps, gently raise the boom allowing the machine
to rock forward onto the transporter bed.
Figure 70.
10. Slew the cab.
Angle: 180°
11. Engage the slew lock.
12. Lower the bucket onto the transporter bed.
13. Crowd the bucket. Position the dipper vertically and lower the boom until the bucket rests on a wooden
block on the trailer bed.
14. Stop the engine.
15. Position a strap of suitable breaking strain over the bucket and secure to the trailer shackles.
16. Place skids under each track at the front and rear to prevent movement of the machine in the fore and
aft direction.
17. Position a strap of suitable breaking strain over the front and rear of the two track legs. Attach the straps
to the trailer shackles to prevent lateral movement of the machine.
18. Attach straps of suitable breaking strain to the kingpost and attach them to the trailer shackles to prevent
the superstructure from slewing.
19. Remove both ramps and attach them in their transport position.
20. Raise any jacks to their transport position.