jcb 8014 CTS, Руководство оператора

Страница: 100 / 208

Attachments
Working with Attachments
88 9821/6100-4 88
Notice: Some attachments may contact parts of the machine when in the fully folded position. Take extra care
to avoid damage to the machine.
Connecting/Disconnecting Hydraulic Hoses
WARNING
Fine jets of fluid at high pressure can penetrate the skin. Keep face and hands well clear of fluid
under pressure and wear personal protective equipment. Hold a piece of cardboard close to suspected leaks
and then examine the cardboard for signs of fluid. If fluid penetrates your skin, get medical help immediately.
WARNING
Hydraulic fluid at system pressure can injure you. Before connecting or removing any hydraulic
hose, residual hydraulic pressure trapped in the service hose line must be vented. Make sure the hose
service line has been vented before connecting or removing hoses. Make sure the engine cannot be started
while the hoses are open.
Some attachments are hydraulically powered. The following procedures show how to connect and disconnect
the hydraulic hoses safely.
Connecting the Hydraulic Hoses
1. Make the machine safe.
Refer to: Maintenance Positions (Page 122).
2. Vent the hydraulic system.
Refer to: Discharge (Page 147).
3. Check the hoses and adaptors for damage.
Refer to: Check (Condition) (Page 147).
4. Connect the hoses:
4.1. Make sure that the hose is not twisted. Pressure applied to a twisted hose can cause the hose to fail
or the connections to loosen.
Figure 73.
4.2. Make sure that the hose does not touch hot parts. High ambient temperatures can cause the hose
to fail.
4.3. Make sure that the hose does not touch parts which can rub or cause abrasion.
4.4. Use the hose clamps (where possible) to support long hose runs and keep the hoses away from
moving parts, etc.
Figure 74.