jcb 535-125 Hi Viz, Руководство по обслуживанию

Страница: 112 / 149

Section 2-2 - Care and Safety
General Procedures
Hydraulic Contamination
2-2-11 2-2-11
9803/3750-05 (2-02-01)
Hydraulic Contamination
TE-002_2
Hydraulic Fluid Quality
Construction machinery uses a large volume of fluid in the
hydraulic system for power transmission, equipment
lubrication, rust prevention and sealing. According to a
survey conducted by a pump manufacturer, seventy per
cent of the causes of problems in hydraulic equipment
were attributable to inadequate maintenance of the quality
of the hydraulic fluid. Therefore, it is obvious that control of
the quality of the hydraulic fluid helps prevent hydraulic
equipment problems and greatly improves safety and
reliability. Furthermore from an economic angle it extends
the life of the hydraulic fluid if quality is maintained.
Effects of Contamination
Once inside the system, hydraulic circuit contaminants
greatly effect the performance and life of hydraulic
equipment. For example, contaminants in a hydraulic
pump develop internal wear to cause internal leakage and
hence lower discharges. Wear particles generated will
circulate with the hydraulic fluid to cause further
deterioration in the performance of this and other
equipment. Contaminants also enter principal sliding
sections of the equipment causing temporary malfunction,
scuffing, sticking and leakage and can lead to major
problems.The main contaminants can be classified as
follows:
1 Solid Particles - sand, fibres, metallic particles,
welding scale, sealing materials and wear particles
etc.
2 Liquid - usually water and incompatible oils and
greases.
3 Gases - Air, sulphur dioxide etc. which can create
corrosive compounds if dissolved in the fluid.
These contaminants can appear during manufacture,
assembly and operation.
Cleaning Operation
The purpose of cleaning oil is to remove contaminants of
all types and sludge by filtering hydraulic fluid through a
cleaning unit.
K
Fig 5. (
T
2-2-11) . General Bulletin 011
also refers.
Procedure
Connect the cleaning unit in place of the hydraulic filter.
K
Fig 5. (
T
2-2-11) . Run the system for sufficient time to
pump all the hydraulic fluid through the unit. Disconnect
the cleaning unit and reconnect the filter. Top up the
system with clean hydraulic fluid as required.
Fig 5. Cleaning Unit
ProCarManuals.com