JC Systems 620A, Справочное руководство

Страница: 11 / 41

Section 1 - SELECT PROGRAM TO RUN Screen
1 – SELECT A PROGRAM TO RUN:
From the Main Menu push <STOP>, <RESET>, <PAGE DOWN> , <1>.
The cursor will be flashing on the Program # field displaying the last program run.
Enter the program number you wish to run using the numeric keypad.
Note: If you wish to start the program on any step other than step# 1.
Push the Right or Left <Arrow>. The cursor will toggle between the program and step number fields.
In the step# field, enter the step number on which you would like the program to start.
Push <RUN>.
The programmer will immediately return to the “Home Screen” and begin running the program from the selected program
and step number.
Caution:
You MUST select a starting step with a Step Type of Ramp/Soak. Pushing <RUN>
on any other step type will cause the 620A to freeze on that step and not execute the
program.
You MUST select a program# that has a valid program in that program# location.
Selecting a program number without programmed information will cause the 620A
to freeze on that program and not execute.
DO NOT select a step number higher than the last step (EOP) of the program.
If a step number is entered higher than the last step (EOP) the display will cycle between
“INVALID ENTRY” and the home screen display.
Pushing <RUN> will reset the step# to step 1 of the displayed program# and run the program.
Pushing <CLR> will reset the step# to step 1 and remain in “Select a program to Run.”