JBT Fresh'n Squeeze 2nd Generation Multi-Fruit..., Руководство оператора

Страница: 23 / 40

23
FNS-0012-060-EN June 2019 Rev A
Self-Service Option Operating Instructions
Equipment Check
Before plugging the Multi-Fruit Juicer into an electrical outlet, the following steps must be
performed:
1. Locate the Multi-Fruit Juicer on a level surface.
This will prevent fruit feed problems.
CAUTION : WHEN MOVING JUICER, ALWAYS TRANSPORT ON LEVEL SURFACE. USE RAMPS
IF NECESSARY. AVOID LEDGES, IRREGULAR FLOORS OR DRAIN INDENTIONS.
2. Lock casters.
To lock, push down on caster with foot. To unlock, push again with foot.
3. Check waste container.
Open cart door to verify that waste container is in place.
4. Check juicing components.
Remove self-service assembly and splash shield, and then check juicing components.
5. Check Self-Service Assembly.
Make sure self-service assembly is fully inserted under the two retaining posts and the spout nozzle
is firmly seated in the manifold. If not present, wet O-ring before installing.
6. Close and turn latch to secure door.
7. Make sure self-service valve handle is released and in the off/closed position.
8. Check the hopper for foreign objects.
Remove any foreign objects found in the hopper.
9. Make sure floor area around Juicer is clean and free of obstructions and water.
Wear appropriate non-slip footwear when water is necessary.