JBT Fresh'n Squeeze 2nd Generation Multi-Fruit Juicer, Руководство оператора

Страница: 26 / 40

26
FNS-0012-060-EN June 2019 Rev A
6. Remove juicing components (see Figure 1).
a. Cups should be separated. (Juicer should have been turned off with maximum separation between
cups using the method described in Step 1.)
b. Remove self-service spout housing assembly by grasping either side of the housing and pulling
straight out, then lift splash shield off mounting brackets.
CAUTION: DO NOT PLACE HANDS OR FINGERS BETWEEN CUPS.
c. Grasp upper cup and pull out pin just above it. Place upper cup in waste container.
d. Using spanner tool and starting at bottom, loosen the strainer tube in manifold, manifold spanner
screw and the spanner nuts securing the lower cup.
CAUTION: CUTTER AND KNIVES ARE SHARP.
e. Install red protective cap on cutter.
(Red protective cap is provided.)
f. Grasp juice manifold and orifice tube firmly. Remove entire juicing components assembly.
g. Grasp orifice tube and pull out of strainer tube.
h. Remove strainer tube from inside juice manifold by turning tube counter-clockwise and sliding out.
(Spanner wrench is provided to loosen/tighten strainer tube.)
Place juicing components into waste container.
7. Prepare cleaning solution.
JBT Corporation brand CorKlean is recommended, see Operator Manual Page 19. Read the product
label. Follow the manufacturer's mixing directions and safety precautions.
8. Immerse all components in cleaning solution.
Use the blunt end of plastic rod provided to displace any fruit material lodged in the bore of the
orifice tube.
Use pointed end of plastic rod to displace any fruit material lodged in cup fingers.
9. Scrub components.
Use a brush, towel, or sponge.
DO NOT
use abrasive pads such as steel wool. Thoroughly rinse
with clean water, then thoroughly rinse with sanitizer solution. Follow the manufacturer's mixing
directions and safety precautions.
10. For best results, soak strainer tube overnight.
After soaking overnight, rinse the strainer tube thoroughly before using. Check that all strainer tube
holes are clean. Clean strainer tube with a hard spray from a hose while moving orifice tube back
and forth in strainer tube. Rinse thoroughly with sanitizer solution. Allow to air dry.