31
FNS-0012-060-EN June 2019 Rev A
Operator Maintenance
Before performing any maintenance,
DISCONNECT ELECTRICAL PLUG.
LOCK FRONT AND REAR CASTER WHEELS.
After every juice run:
1. Check cutter and knives for sharpness.
Refer to
Figure 8
to determine condition of cutter.
If dull, sharpen with a whetstone provided.
Refer to
Figure 8
to sharpen cutter.
If cutter is severely damaged or rolled over, replace cutter.
a. Cutter removal:
Disassemble juicing components (Figure 6, Page 22). Loosen set screw under front knife
(make sure screw is backed out far enough to clear cutter). Cutter should lift out, if not, tap
the cutter lightly from inside the juice manifold with a 1-1/4" diameter rod (hammer handle).
CAUTION: CUTTER AND KNIVES ARE SHARP.
Install red protective cap provided onto cutter. After red protective cap is installed, remove
cutter. Handle cutter with care to avoid direct contact with sharp edge.
b. Cutter installation:
Align arrows on cutter and juice manifold to seat cutter. Make sure cutter is fully seated.
Tighten set screw.
(DO NOT
over-tighten
.)
Содержание Fresh'n Squeeze 2nd Generation Multi-Fruit Juicer
