1
2
17
40 mm
50 mm
60 mm
80 mm
100 mm
130 mm
130 mm
para manuales - color gris
200 mm
300 mm
Note:
The chamfered side has
to be positioned towards the
handle.
2. Mounting Position
3. Inserting Sealing Plug
1. Removing Sealing Plug
Push the sealing plug inside
the handle until the sealing
plug and handle edges are
aligned.
Introduce a small shaft or
screwdriver, not deeper than
8 mm, lift and pull the sealing
plug. Never use a cartridge to
do this operation.
Handle
Chamfered
Side
Tool Charger Dissasembly and Replacement
Tool chargers can be disassembled by loosening the
screws (1) at the bottom of the charging-base and
pulling downward from the side band (2).
Before sliding down the side band, hold the tool
charger with your hand to prevent it from falling down.
Then, to install a new tool charger onto the charging-
base, place the tool charger at the top of the side rail
and slide back the slide band over it until it is secured
in place and tighten the screws at the base.
Find more information about Expansion Kits on
www.jbctools.com.
Side Band