background image

TM

Soldering & Rework Station

Features:

•   Closed loop control of sensor, accurate and stable temperature, which can  

safely desolder the temperature-sensitive components, such as QFP, PLCC, 

SOP, BGA and so on Intelligent cooling system, Delay blast after operation, 

automatic power off when air   temperature is less than 100°C

•   Original imported heating element, rapid warming, and long life, and good  

wielding safety performance, constant and adjustable temperature

•   Original imported air pump, low vibration, noise design, which can make the 

workplace quiet

•   Anti-Static design to avoid bringing damage to PCB board due to static and 

creepage

Apply:

R and D
production

lab of scientific research

Specifications:

Input voltage  

: 110V / 220V AC optional

Maximum power consumption  

: 550W

Air pump  

: Diaphragm

Volume 

: 23L / min (max)

Temperature   

: 100°C to 480°C

Dimension  

: 224mm (L) × 126mm (W) × 110mm (H)mm

Before Operation:

1.  

 Select the Nozzle that matches the size of the IC attach the Nozzle when both the pipe and the Nozzle are cool. Should 

either be warm, check to make sure that the temperature control knobs set to1

2.  

Loosen the screw on the Nozzle

3.  

 Attach the Nozzle. Do not force the nozzle or pull on the edge of the Nozzle by pliers. Also, do not re-tighten the screw 

too tightly

Operating Instructions:

1. 

 Plug the power cord into the power supply. After connection, the automatic blowing function will start sending air 

through the pipe, but the heating element remains cool

2. 

 Turn the Power switch on. The power switch may be turned on at any time while the automatic blowing function is 

operating. Once the power switch is turned on, the heating element will begin to warm up

3. 

 Adjust the air flow and temperature control knobs. After adjusting the air flow and temperature control knob, wait for 

the temperature to stabilize for a short period of time

4. 

 Melt the solder. Hold the iron so that the Nozzle is located directly over, but not touching the IC and allow the hot air to 

melt the solder. Be careful not to touch the leads of the IC with the Nozzle

5.  

Remove the IC. Once the solder has melted, remove the IC by lifting the plier

6. 

 Turn the power switch off. After the power switch is turned off, an automatic blowing function begins sending cool air 

through the pipe in order to cool both the heating element and the handle. So do not disconnect the plug during this 

cooling process. In case you don’t use the unit for a ling time, disconnect the plug

7. 

Remove any remaining solder. After removing the IC, remove remaining solder with a wick or desoldering tool

Note: 

After turn off the power switch of about 1 minute later, power is automatically shut off.

:טירפ רואית

 

 תנחת

םח ריווא

 

תילטיגיד

 

560W

 

 :ןרצי

TENMA

 

 :םגד

21-10125

 

 :רימלט ט"קמ

2362602

 

המחלה תונחת / המחלה תונחתו םימחלמ / המחלה דויצו םימחלמ :רתאב םוקימ

 

מ"עב הקינורטקלא רימלט :ןאובי

 

Отзывы: