ENGLISH
USER MANUAL
JB SYSTEMS
®
3/9
LED FAN RGB
DESCRIPTION:
1. DISPLAY
shows the various menus and the selected functions.
2. MENU button:
used to browse the different functions in the
menu
3. UP button:
to increase the values shown on the display.
4. DOWN button:
to lower the values shown on the display.
5. ENTER button:
used to confirm your choice or to enter the
setup mode of a function.
6. M-DMX INPUT:
Please note that this USB-connector is
NOT used for updates or to connect the unit to a PC!
Instead this USB-connector makes it very easy to add
wireless DMX to the unit! Just add the (optional) WTR-
DMX DONGLE from BRITEQ
®
and you will get wireless
DMX! Moreover you will be able to connect other DMX-
controlled equipment to the DMX-output so you can
share the wireless DMX function with all connected
units! No extra settings to be made in the setup menu,
just follow the procedure in the user manual supplied
with the WTR-DMX DONGLE from BRITEQ
®
.
The
separate WTR-DMX DONGLE is available from
WWW.BRITEQ-LIGHTING.COM (order code: 4645)
.
7. DMX INPUT:
3pin male XLR-connector used to
connect the unit with the DMX controller or with the
previous unit in the DMX chain.
8. DMX OUTPUT:
3pin female XLR-connector used to
connect the unit with the next unit in the DMX chain.
9. Mains input:
connect the supplied mains cable here.
10. Mains output:
you can use a special PowerCON
®
power cable to connect this output with the mains
input of the next LED FAN RGB for easier linking up to 10A. Always pay attention to the maximum load
while adding projectors! Special Multi cables PowerCON
®
+ DMX XLR-cables are available on the
market
11. MAINS FUSE:
protects the unit in case of electrical problems, always use the prescribed fuse!
12. POWER SWITCH:
used to switch the power of the unit on / off
OVERHEAD RIGGING
•
Important:
The installation must be carried out by qualified service personal only. Improper
installation can result in serious injuries and/or damage to property. Overhead rigging requires
extensive experience! Working load limits should be respected, certified installation materials
should be used, the installed device should be inspected regularly for safety.
•
Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging
and servicing.
•
The device should be installed out of reach of people and outside areas where persons may walk by or be
seated.
•
Before rigging, make sure the installation can hold a minimum point load of
10times the device’s weight.
•
Always use a certified safety cable that can hold 12times the weight of the device when installing the unit.
This secondary safety attachment should be installed in a way that no part of the installation can drop
more than 20cm if the main attachment fails.
•
The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!
•
Don’t cover any ventilation openings as this may result in overheating.
•
The operator has to make sure that the safety-relating and machine-technical installations are approved by
an expert before using them for the first time. The installations should be inspected every year by a skilled
person to be sure that safety is still optimal.
