JB Systems DELUSION, Руководство по эксплуатации, Страница: 8 / 12

ENGLISH OPERATION MANUAL
JB SYSTEMS
6/8 DELUSION
Defa
Used to reset the default options
•
Press the [MENU] button or [UP/DOWN] buttons until the desired function is showing on the display.
•
Press the [ENTER] button: The values can be changed.
vEr
Used to reset the default options
•
Press the [MENU] button or [UP/DOWN] buttons until the desired function is showing on the display.
•
Press the [ENTER] button: The values can be changed.
ELECTRICAL INSTALLATION
Important: The electrical installation should be carried out by qualified personal only,
according to the regulations for electrical and mechanical safety in your country.
Master / Slave mode:
Connect the projectors together as shown on the drawing. Please refer to the paragraph “SETUP MENU”
to setup the master. All slaves must be set to SLAVE-mode.
Electrical installation for two or more units in DMX-mode:
•
The DMX-protocol is a widely used high speed signal to control intelligent light equipment. You need to
“daisy chain” your DMX controller and all the connected units.
•
Pin layout XLR-3pin: Pin1 = GND ~ Pin2 = Negative signal (-) ~ Pin3 = Positive signal (+)
•
To prevent strange behavior of the light effects, due to interferences, you must use a
90Ω to 120Ω terminator at the end of the chain. Never use Y-splitter cables, this
simply won’t work!
•
Make sure that all units are connected to the mains.
•
Each unit in the chain needs to have its proper starting address so it knows which
commands from the controller it has to decode.