JB Systems DELUSION, Руководство по эксплуатации, Страница: 6 / 12

ENGLISH OPERATION MANUAL
JB SYSTEMS
4/8 DELUSION
OVERHEAD RIGGING
Important: The installation must be carried out by qualified service personal only. Improper
installation can result in serious injuries and/or damage to property. Overhead rigging requires
extensive experience! Working load limits should be respected, certified installation materials
should be used, the installed device should be inspected regularly for safety.
•
Make sure the area below the installation place is free from unwanted persons during rigging, de-
rigging and servicing.
•
Locate the fixture in a well-ventilated spot, far away from any flammable materials and/or liquids. The
fixture must be fixed at least 50cm from surrounding walls.
•
The device should be installed out of reach of people and outside areas where persons
may walk by or be seated.
•
Before rigging make sure that the installation area can hold a minimum point load of
10times the device’s weight.
•
Always use a certified safety cable that can hold 12times the weight of the device when
installing the unit. This secondary safety attachment should be installed in a way that no
part of the installation can drop more than 20cm if the main attachment fails.
•
The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!
•
Don’t cover any ventilation openings as this may result in overheating.
•
The operator has to make sure that the safety-relating and machine-technical installations are approved
by an expert before using them for the first time. The installations should be inspected every year by a
skilled person to be sure that safety is still optimal.
SETUP MENU / HOW TO SETUP
Addr d.001-512
CHnd 3/5/7CH
SLnd SL-1/2
mASt On/off
SHnd Sh0-Sh8 SP0-99
SoUn On/off
SEnS 0-100(80)
dMSt
bLnd
LAst
Show
LEd On/off
diSP Disp/dsip
TEmP
xxx Temperature
FHrS
xxxx Fixture Hour
DeFA Yes or No Factory Default
vEr vxxx Software version
Addr
Used to set the desired DMX-address.
•
Press the [MENU] button or [UP/DOWN] buttons until the desired function is showing on the display.
•
Press the [ENTER] button: the DMX value can now be changed
•
Use [UP/DOWN] buttons to select the desired DMX512 address.
•
Once the correct address shows on the display, press the [ENTER] button to save it.
CHnd
Used to set the desired DMX mode.
•
Press the [MENU] button or [UP/DOWN] buttons until the desired function is showing on the display.
•
Press the [ENTER] button: the DMX mode can now be changed
•
Once the correct mode shows on the display, press the [ENTER] button to save it.