ENGLISH
USER MANUAL
JB SYSTEMS®
12/12
SPYDER-RGB LASER
MAINTENANCE
•
Make sure the area below the installation place is free from unwanted persons during servicing.
•
Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
•
All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
•
Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
•
When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
•
The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
•
In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
•
The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
•
The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to
optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp,
smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit’s optics.
•
Clean with a soft cloth using normal glass cleaning products.
•
Always dry the parts carefully.
•
Clean the external optics at least once every 30 days.
•
Clean the internal optics at least every 90 days.
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!
SPECIFICATIONS
Mains Input:
AC 100~240V, 50/60Hz
Fuse:
250V 1A slow blow (20mm glass)
Total Power consumption:
30W
Sound Control:
Internal microphone
DMX connections:
3pin XLR male / female
DMX channels:
6/9/10 channels
DMX starting address:
001
→
503
Laser Power:
120mW Red CW laser (
λ = 638nm)
50mW Green CW laser (
λ = 520nm)
300mW Blue CW laser (
λ = 450nm)
Laser radiation class:
3B
Beam diameter @ aperture:
<5mm
Divergence (each beam)
<2 mrad
MPE / NOHD:
Not relevant, the beam is continuously scattered and
moves in all directions (no stationary laser beam)
Divergence (total output)
<90°
Working temperature:
10°C to 40°C
Laser Safety Standard:
EN/IEC 60825-1:2014
Size:
see picture below
Weight:
2.35kg
Every information is subject to change without prior notice
You can download the latest version of this user manual on our website :
Содержание B06222
