JB Systems B06222, Руководство по эксплуатации

Страница: 9 / 16

ENGLISH USER MANUAL
JB SYSTEMS®
7/12 SPYDER-RGB LASER
•
Connect the DMX input of the laser to the DMX output of the previous unit in the chain or directly to the
DMX-output of your controller.
•
Press the FUNC-button until the dis
play shows: “001” or the actual DMX-address.
•
Press the UP/DOWN buttons to select the desired DMX-address. (001 to 503)
•
Press the ENTER-button to confirm your choice.
•
Press the FUNC-button again if you want to change the address.
Note: the display blinks when the unit is in DMX-mode and no DMX-signal is detected.
Some more information on DMX512:
The DMX-protocol is a widely used high speed signal to control intelligent light equipment. You need to
“daisy chain” your DMX controller and all the connected light effects with a good
quality XLR M/F balanced cable. To prevent strange behavior of the light effects,
due to interferences, you must us
e a 90Ω to 120Ω terminator at the end of the chain.
Never use Y-
splitter cables, this simply won’t work!
Each effect in the chain needs to have its proper starting address so it knows which
commands from the controller it has to decode.
DMX-CONFIGURATION OF THE LASER:
IMPORTANT REMARK :
The value of CH1 is used to put the laser in the desired DMX-mode.
The SPYDER-RGB LASER has 3 DMX-modes : 6, 9 and 10 channels.
o
6CH-mode : Fader CH1 between 175 and 199
o
10CH-mode : Fader CH1 between 200 and 224
o
9CH-mode : Fader CH1 between 225 and 255
Channel Value
Function
CH1
Mode
000-024 Laser off
025-049
Mixed show Auto. P grating
050-074 Mixed show sound P grating
075-099 Pattern show Auto
100-124 Pattern show sound
125-149 Grating show Auto
150-174 Grating show sound
175-199 Grating dot show DMX
200-224
Grating pattern show DMX
225-255 Original pattern show DMX