JB-Lighting SPARX 7, Руководство по эксплуатации

Страница: 31 / 48

4.2 FACTORY DEFAULTS
4.4 DMX ADDRESS - DMX addressing
Change the DMX address directly by means of the keys "UP" and "DOWN". Confirm and
store it by pressing key "ENTER". The DMX address can also be changed in the menu
DMX ADDRESS .
To set back the Sparx7 to factory setting choose menu point FACTORY DEFAULT, LOAD
DEFAULTS. After confirming SURE ? in the display, the personal settings of the Sparx7
will be set back to factory default.
If the white balance was adjusted before, it will be not affected by the set back to factory
default.
31
4.5 PERSONALITY
DMX MODE
The Sparx7 offers 3 different operating modes (see DMX protocol page 34). For using the
full range of DMX channels use the Mode 2 - 16 BIT. Use this mode for smoother operation
with the RGBW channels. In order to operate the Sparx7 with less DMX-channels the
DMX Mode can be set to Mode 3. In this mode the patterns running only between color
wheel and RGBW channels.
PAN/TILT
RESOLUTION sets pan and tilt to 8 bit or 16 bit control resolution. The default setting is
16 bit. If this fine resolution is not required, you can set to 8 bit for quicker operation of
pan/tilt values. The
PAN INVERS and TILT INVERS commands invert the direction of pan
and tilt. The PAN/TILT SWAP command sets pan commands to tilt and vice versa.
CURVES
Dimming curves can be adjusted for the dimmer channel and the RGBW channels. There
is a square-law curve for finer control at low intensity and coarser control at high intensity
and a linear-law curve available.
SHORTEST DISTANCE
This setting is only for the colour wheel channel. On ON (default) it always take the
shortest route from one colour to another in order to simulate a physical colour wheel. On
OFF it routes only from white to cyan and backwards.
DMX INPUT MODE
The Sparx7 provides an embedded radio-DMX receiver. The receiver works with the JB-
Lighting Wireless TRX transmitter. To enable the Sparx7 to receive radio-DMX change the
menu from
WIRED (factory default) to WIRED/WIRELESS . The fixture needs to be logged
-in to the Wireless TRX transmitter. To log-in press the „Start“ button (see also manual
Wireless TRX). The radio channel is displayed when the Sparx7 is logged. The main
display will show the intensity of the incoming signal. If the Sparx7 is connected either via
DMX cable and radio-DMX, the cable signal has priority.
4.3 USER DEFAULTS
If the personal settings are done in the PERSONALITY menu, the user can save and re-
load it in the USER DEFAULTS menu. To make sure that the personnal settings are not
changed quickly on a stage, the save progress is locked with the password "JB-lighting".