JB-Lighting P18 Wash, Руководство по эксплуатации

Страница: 16 / 32

- 16 -
P18 Wash
5.2 FACTORY DEFAULTS - Factory settings
To reset P18 Wash to the factory settings, go to the menu item FACTORY DEFAULTS, LOAD
DEFAULTS. After confirming the security prompt SURE? with “ENTER”, all parameters are reset
to the factory settings.
5.3 USER DEFAULTS - User settings
If the user has set the P18 Wash in the PERSONALITY menu to their personal settings, these can
be saved and loaded in the USER DEFAULTS menu. In order to prevent unintentional alteration
of the data, you must enter the following password during the saving process: “JB-LIGHTING”.
5.4 DMX / NET ADDRESS - DMX addressing / Artnet addressing
The DMX addressing can be done either directly in the display. Press the "UP" or "DOWN"
button to set the desired DMX address. The value is confirmed with the "ENTER" key. However,
the DMX addressing can also be done within the menu item DMX / NET ADDR, and there under
DMX ADDRESS.
To set the Artnet address, the menu item ARTNET ADDRESS must be selected in the DMX
/ NET ADDR menu. The Artnet address can now be set using the UP / DOWN buttons. The
Artnet address is displayed in the form 000.00.00. This display corresponds to: Netz.Subnetz.
Universum.
5.5 PERSONALITY - Personal settings
DMX INPUT MODE
In this menu item the options WIRELESS and NETWORK are available.
Under WIRELESS -> ON / OFF the factory-installed radio DMX receiver module of Lumen-Radio
can be activated or deactivated and via WIRELESS -> UNLINK the connection to the connected
transmitter can be deleted. In order to connect the fixture to a transmitter, wireless must be
set to ON on the fixture and the connection button must be pressed briefly on the transmitter.
The transmitter is now looking for all fixtures where wireless is enabled and fixtures that are not
connected to a transmitter. If the P18 Wash has successfully connected to the transmitter, the
display shows a level indication of the current reception quality. If the P18 Wash is additionally
connected via the DMX / etherCON connection sockets, these signals have priority over the
radio link. Using the key shortcut ESC and DOWN, pressed in the main menu, the headlamp can
be booked out of the booked transmitter (see page 19).
Under NETWORK -> ARTNET, the IP address of the fixture must be selected or set for Artnet
operation. Each fixture has a unique standard IP address. Under ARTNET -> DEFAULT-IP this
can only be changed from the network 10.xxx.xxx.xxx to a network 2.xxx.xxx.xxx. You can set
your own customer-specific IP address under ARTNET -> USER-IP. This address is divided into
BYTE1 to BYTE 4 and can be set one after the other.
DMX MODE
The P18 Wash has 2 operating modes (see channel assignment page 20). All parameters of
P18 Wash can be operated via mode 1. However, all channels (except pan/tilt) are controlled with
8 bits. By selecting Mode 2 - 16 Bit the gobo, prism rotation, CMY/CTO, dimmer, focus, zoom,
the complete shutter slide unit as well as pan/tilt are controlled via 16 Bit.
PAN/TILT
The motion resolution can be changed from 16 bits to 8 bits under RESOLUTION. In the factory
setting, this is set to 16 bits. In 8-bit resolution, the P18 Wash can be positioned less precisely,
but can be operated more rapidly depending on the lighting console. The menu items PAN
INVERSE and TILT INVERSE allow you to invert the direction of movement. Under PAN/TILT
SWAP, the “Pan” and “Tilt” channels can be interchanged.