- 8 -
7.THE RELEASE HANDLE & CORD
• Thread one end of the rope
through the hole in the
top of the red release handle so
that “NOTICE”
reads correctly.
• Secure with an overhand knot at least 25 mm from
the end of the rope to prevent slipping.
• Thread the other end of the rope through the loop
of the manual release cable.
• Adjust rope length so the handle
(when installed)
will be no higher than 1.8 m above the floor. Secure with an overhand knot.
NOTE: Final adjustment of handle height should be completed after the opener is installed. If it is
necessary to cut the rope, heat seal the cut end to prevent unravelling.
8.OPERATING THE MANUAL RELEASE
To disengage the opener
Pull the release cord down firmly
；
To re-engage the opener
Pull the release cord down firmly
；
NOTE:
Disable all locks and remove any ropes connected to
the garage door.
Take care when operating the manual release as an
open door may fall rapidly due to weak or broken
springs.
