- 5 -
Maintain a minimum gap of 30mm between the top panel and the bottom of the rail (Fig. 4).
Make sure the track is horizontal. Place a spirit level on the track if required. Make sure the connection of the hanging
bracket is firm and secure (Fig.5, F)
Warning:
Make sure the opener is affixed to a solid mounting point or joist and not to plasterboard. Failure to have a
safe and secure fixing can lead to opener falling and may cause serious damage and/or personal injury.
Installation (steel track)
1. Fix the wall bracket(B) to the wall 2cm-15cm above the torsion shaft or spring and central to the door.
2. Fix the steel track to the wall bracket using axis pin
Φ
8x80 (C) and cotter pin. (Fig. 5)
3. Fix garage door opener to the track using 2 x U brackets supplied(E). Then fasten using M6 nuts x4 supplied.
4. Fix the hanging bracket(F) to the edge of the opener as in Fig. 5 using M6x16 carriage bolts and/or rail hanger
supplied. If using rail hanger, bend tabs down after fixing to the track to secure.
Fig.3
Fig.4
Fig.6
Fig.5
