Jayco WHITE HAWK TOWABLES 2022, Руководство пользователя

Страница: 72 / 165

66
Section 5: Slideout Systems
6 Minor
Supply voltage to
control box is 17 0 V DC
or greater
Check 2-pin power connector
at control box. If the voltage
is 17. VDC or higher, contact
O.E.M for power and ground
supplies
Park brake LED flashing
-Parking brake not set
(if applicable)
-Ground signal lost at
park brake control
-Set parking brake (if ap-
plicable)
-Check for continuity to
ground on wire plugged
into park brake connector at
control box.
Low voltage LED flashing
Incoming violated to
control box is below
12.0 VDC
Check 2-pin power connec-
tor at control box. If voltage
is below 12.0 VDC contact
O.E.M for power and ground
supplies.
Preventative Maintenance
The Power Gear® slideout system requires very little maintenance. Read and follow these
procedures:
 When the room is extended, visually inspect the slide rail assemblies. Check for
excess buildup of dirt or foreign material; remove any debris that may be present.
 If the system squeaks or makes any noises, blow out any debris from the gear rack
arms and apply a dry lubricant to prevent and/or stop squeaking.
Refer to the Power Gear® website www.powergearus.com for additional information.
Override Modes
In the event of component failure or loss of system power, your slideout can be manually
overridden and retracted for travel.
Emergency Retract Mode
Use this procedure when there is NO loss of power or electrical problem with the system.
1. Remove the touchpad (Fig 4) from the wall.
NOTE: During the override procedure, the unit will exit this mode if the
room has not been moved for two (2) minutes or if a fault is detected dur -
ing room movement. The Fault Code (RED) and Room or Lock Movement
(GREEN) LEDs will flash rapidly for 10 seconds to indicate the override
procedure failed. After 10 seconds of flashing, the control will automatically
default to FAULT CODE 1. Programming must be restarted.
NOTE: After overriding the system, the room control will need to be re-
programmed by an OEM authorized dealer.
Table of Contents Maintenance Record