Jayco WHITE HAWK TOWABLES 2022, Руководство пользователя

Страница: 71 / 165

65
Section 5: Slideout Systems
Fault Diagnostics / Troubleshooting:
The control has the ability to detect and display several faults. When a fault is detected,
room movement stops and two different LEDs will flash in a pattern.
The RED FAULT CODE LED will flash a number of times corresponding to a specific fault
code (refer to the Fault Code Chart).
The GREEN ROOM MOVEMENT LED will flash GREEN a number of times correspond -
ing to which motor has the associated fault.
Example: (4) RED flashes and (2) GREEN flashes indicate a motor fault on motor 2.
MAJOR and MINOR faults ; faults must be cleared for the room to operate normally.
 MINOR faults can be cleared by pushing and releasing the IN or OUT buttons
on the wall touchpad.
 MAJOR faults must be cleared by pushing and releasing the SET STOPS/CLEAR
FAULTS button located on the back of the wall touchpad.
F a u l t
Code
F a u l t
Type
Fault Codes
Description
Possible Cause Possible Solution
1 Major Stops not
programmed
-Stops have not been
set
-Stops were cleared
-Stops were improperly
set
Steps need to be pro-
grammed by an authorized
service facility.
2 Minor System Fault
-Obstruction present
-Excessive system drag
Run room in opposite direc-
tion. If it continues to move
in the opposite direction,
remove obstruction, exces-
sive weight in room or repair
of damaged component. If
room stops moving in oppo-
site direction, observe fault
code and refer to this chart
4 Major
Excessive
Battery
Voltage
-Bad or loose connec-
tion
-Defective harness
-Open or shorted motor
-Check all connections at
control box and motor.
-Check the harness for bro-
ken wires.
-Put 12.0 VDC direct to the
motor. If it does not run,
replace the motor.
NOTE: For MAJOR faults, the control must be overridden by following
the EMERGENCY RETRACT MODE in the Overrides Modes section .
Table of Contents Maintenance Record