Jayco WHITE HAWK TOWABLES 2022, Руководство пользователя

Страница: 58 / 165

52
Section 4: Vehicle Operation
 Do not allow the corner of the entry door to contact the awning fabric. Otherwise,
premature wear or tearing of awning fabric could occur.
 Never close the awning (for storage) when wet. The combination of moisture and
dirt could result in mildew, discoloration, and stains. If it is necessary to roll up
awning (temporarily) while it is wet, make sure you roll it out and let it dry (as
soon as conditions allow) before rolling it up again.
 Do not allow dirt, leaves, or other debris to accumulate on the awning, which
could cause abrasion and stains. Mildew could grow on dirt and organic debris,
causing permanent discoloration, stains, and odors to the awning fabric.
 Do not use strong chemicals or abrasives to clean parts, as their protective sur-
faces will be damaged. Clean awning hardware (as needed) with a mild surface
cleaner.
 Apply silicone spray lubricant as needed to the moving parts on the fabric roller
tube assembly.
 Lubricate all pins and sliding surfaces of the arm assemblies with silicone spray,
as needed.
 Do not use abrasive or corrosive cleaners, mildew removers, or hard bristle brush-
es on the awning fabric.
Vinyl awning fabric is durable and water resistant. Wrinkling is a normal characteristic,
which may be more noticeable when the awning is retracted, and after prolonged periods of
stowage (rolled up).Leave the awning open during warm weather to minimize wrinkling. A
slight “travel line” may appear where the door roller (if installed) contacts the fabric. This is
normal and does not affect the integrity of the fabric.
To clean the fabric:
 Open the awning.
 Mix 1/4 cup dish soap and 1/4 cup bleach with five gallons of fresh water.
 Liberally drench the fabric with cleaning solution.
 Close the awning and allow the cleaning solution to soak for five minutes.
 Open the awning and thoroughly hose off the top and bottom of the fabric with
clean water. Repeat if necessary.
 Remove the solution COMPLETELY from the awning fabric. Bleach will degrade
the fabric if it is not completely rinsed off.
 Make sure the fabric is dry before closing the awning.
Your recreation vehicle may include one or more of the following options:
 Power window awnings
 Slide out awnings
 Power awning over entrance door
Power switches to operate the awnings are typically found in the control panel above the
entrance door or if your RV has a touchscreen, the awning controls may be located there.
Power Awnings (if so equipped)
Each power awning will have its own control switch. Pressing and holding the switch will
extend or retract the awning. The awning should automatically stop when the switch is
released.
NOTE: Electric awnings requires connection to a 120-volt power source.
Make sure you have sufficient power available before operating your
awning (refer to Electrical Systems, Calculating electrical load).
Table of Contents Maintenance Record