Jayco WHITE HAWK TOWABLES 2022, Руководство пользователя

Страница: 122 / 165

116
Section 8: Plumbing System
2. Remove the sewer hose housing dust cap and attach
the sewer hose (customer supplied).
3. Place the end of the sewer hose into the approved
dump station.
4. Open the black tank dump valve (depending on your
model the valve may be located under the RV, or on
the utility center). Close the dump valve when the
black water holding tank is empty.
5. Open the grey tank dump valve (depending on your model the valve may be located
under the RV or on the utility center). Close the dump valve when the grey holding
tank is empty.
6. Remove, clean and store the sewer hose.
7. Close the sewer hose housing dust cap.
You can locate dump stations throughout the United States and Canada in Woodall’s, Rand
McNally Camp Guide, Good Sam Camp Guide, KOA Kampgrounds Camp Guide and vari-
ous other publications. Some fuel stations also have dump stations.Please contact your RV
dealer for assistance in the purchase and installation of a sewer hose or sewer hose extension
(if needed).
Sewage (black) tank preparation
1. Release one to two quarts (1 or 2 liters) of water into the toilet bowl.
2. Follow the directions on your RV-approved toilet chemical bottle (customer supplied)
and put the recommended quantity of holding tank chemical into the toilet bowl.
3. Flush the toilet and allow at least two gallons (8 liters) of water to flow into the holding
tank.
Waste (grey) holding tank preparation
No special preparation is required, however, placing a small quantity of chemicals into this
tank, such as baking soda or an approved RV chemical, will reduce odors from food particles
in the system.
Cleaning and Maintenance
The toilet should be cleaned regularly for maximum sanitation and operational efficiency.
Use only RV approved chemicals. Do not use chlorine (undiluted) or caustic chemicals,
such as laundry bleach or drain opening types, in the toilet system. These products damage
the seals in toilets and dump valves.
It is important to add enough water to prevent solid waste buildup. Follow the
directions listed below and in the manufacturer’s operator manual.
Black/Grey Tank Drain and
Valves
Black Tank Flush (if so equipped)
The black tank flush (no fuss flush) inlet is typically located on the utility center panel (if
so equipped) labeled as “Tank Flush”. For models not equipped with a utility center, the
inlet is located on the side of the recreation vehicle. The location may vary depending on
your model. Attach a garden hose (connected to a pressurized fresh water source) to the
black tank flush inlet. The water goes directly into the black water holding tank sprayer
connection, allowing you to remove debris and preventing accumulation. A check valve is
incorporated in the plumbing lines to prevent back flow. Flush the black water tank each
time the grey and black water holding tanks are dumped or as needed.
Table of Contents Maintenance Record