Jayco Kiwi Travel Trailer 2003, Руководство пользователя

Страница: 43 / 55

77 76
CORRECT WAY
TIRE LIFT MOUNTING SURFACE
TIRE CONTACT SURFACE
VALVE STEM
down
Lift Plate
6 in. Cable
VALVE
STEM
UP
LIFT PLATE BOTTOMED
OUT AGAINST LIFT
NO
CABLE
TIRE LIFT MOUNTING SURFACE
TIRE NOT IN CONTACT
WITH SURFACE
TIRE
CONTACT
SURFACE
WRONG WAY
BBQ GRILL (Option)
An option for your travel trailer is a BBQ Grill. This grill is for use outside of the travel
trailer and comes with a bracket to attach to the side of the unit. The following list will
supply basic operations for the grill. Be sure to read all instructions included with the
grill.
1. Install the grill bracket on the side of the travel trailer mounting bracket. Make sure
that it is securely in place.
2. Place the BBQ grill into the bracket. (Fig. 7-3)
3. Attach the fuel hose to the grill and the LP gas connection located under the travel
trailer by using the “Quick-Coupler” instruction as follows (Fig. 7-4):
• Place the handle in the “OFF” position and push back the sleeve. Valve handle
must be in the “OFF” position to make the connection. (Fig. 7-5)
• Insert the plug and release the sleeve. (Fig. 7-5)
• Push plug until the sleeve snaps forward, locking the plug into the socket.
(Fig. 7-6)
• Turn handle to “ON” position to turn gas on. (Fig. 7-7)
4. Open the lid to the BBQ Grill.
5. Using an electric match, light the grill using the following procedures:
• Light the electric match.
• Insert it into the middle slot on the bottom of the BBQ Grill.
• On the grill control knob (Fig. 7-4), depress and turn the knob to the desired
temperature.
• The grill should light at this point.
6. If the grill does not light, turn the gas off, wait five minutes and repeat the above
steps.
7. Use the temperature control knob to adjust the grill to the desired temperature.
CHAPTER 7
OPTIONS
SPARE TIRE CARRIER
Kiwi
The spare tire is transported in a carrier mounted under the front A-frame and may be
pre-installed providing it is part of your purchase agreement. To operate it, follow these
instructions:
1. Remove the wing nut with the rod, loosening the tire.
2. Remove the pin from the latch hook at the battery carrier.
3. Pull the hook toward the travel trailer and carefully lower it.
1
CAUTION: Keep all objects from under the carrier while lowering the front
end to avoid damage.
4. Slide the tire out from either side. Reverse the procedure to reinstall.
Kiwi Too
The following procedures should be used in securing the spare tire in the travel position:
1. Put the steel hoist lift support located on the end of the cable through the rim of the
tire. Clips need to seat inside of the hole.
The valve stem of the tire MUST be pointed in the down position or away from the
bottom of the travel trailer. Reference Fig. 7-1.
The hoist will not seat the tire correctly if the valve stem is toward the bottom of the
travel trailer. Reference Fig. 7-2.
2. Use the crank handle to lift the tire into the travel position. Two crisp breaks must
be heard and felt to insure proper seating of the tire for travel.
The tire must be in contact with the surface to be in the travel position.
1
WARNING: DO NOT exceed the maximum load capacities of 100 lbs.
for the hoist. DO NOT use air driven guns or impact wrenches to lift the
tire into the travel position.
Fig. 7-2
Fig. 7-1
Fig. 7-3
Fig. 7-4
Fig. 7-5 Fig. 7-6 Fig. 7-7