Jayco Kiwi Travel Trailer 2003 Скачать руководство пользователя

Страница: 31 / 55

To Turn Off Gas to Appliance

1. Set the thermostat to lowest setting.

2. Turn off all electric power to the appliance if

service is to be performed.

3. Open the access panel (Outer Door Assembly)

to turn off the electric switch.

4. Close the control access panel (Outer Door

Assembly).

Ducting and Return Air

All heat discharges, registers and return air grills must be free and clear of obstructions.
Obstructions will prevent the furnace from performing correctly. This includes all
closable registers that are intended to reduce air flow, not shut it off completely.

For complete operation of furnace, see the operation manual supplied and published by
the manufacturer of this furnace.

STOVE

Drop-in Cooktops

A top mounted drop-in stove does not have a standing pilot light. Each time you wish to
operate the stove, it must be lit manually. Ensure that the LP gas supply is turned on and
that there is a sufficient supply.

All top burner and oven controls operate counterclockwise and must be pressed inward
(towards the cooktop) to turn ON. Turn the control clockwise to turn it OFF and
extinguish the burner flame.

1. To light the top burners:

a. Turn the appropriate burner knob fully counterclockwise to ON. Do not attempt

to light more than one burner at a time.

b. IMMEDIATELY light the burner by holding a lit match or a hand-held spark

igniter designed for this purpose near the burner ports.

c. To extinguish the top burner flame, turn the appropriate burner knob clockwise

to “OFF.”

WARNING:

Ensure that stove knobs are pushed all the way onto the

stems in the “OFF” position. Failure to do so could result in the stove

inadvertently being turned on. If camping with small children, you may want
to utilize stove knob covers that are available at your local hardware.

For Your Safety Read Before Operating

WARNING:

If these instructions are not followed precisely, a fire or

explosion may result causing property damage, personal injury or loss

of life.

This appliance does not have a pilot light. It is equipped with an ignition device that
automatically lights the burner. Do not try to light the burner by hand.

Prior to operation, smell the area around the appliances to ensure that gas has not
settled on the floor.

WHAT TO DO IF YOU SMELL GAS

• Evacuate all persons from the vehicle.
• Shut off the gas supply at the gas container or source.
• Do not touch any electrical switch or use phone or radio in the vehicle.
• Do not start the vehicle’s engine or electric generator.
• Contact the nearest gas supplier or qualified service technician for repairs.
• If you cannot reach a gas supplier or qualified service technician, contact the

nearest fire department.

• Do not turn on the gas supply until the gas leak(s) has been repaired.

Use only your hand to turn a gas control valve. Never use tools. If the valve will not
turn by hand, do not try to repair it. Call a qualified service technician. Using force
may result in a fire or explosion.

Do not use the appliance if any part has become wet. Immediately call a qualified
service technician to inspect and replace any part of the control system and gas
control which has been under water.

Operating Instructions

1. STOP! Read the safety information above.

2. Set the thermostat to lowest setting.

3. Turn off all electric power to the appliance.

4. This appliance is equipped with an ignition device which automatically lights the

burner. Do not try to light the burner by hand.

5. Open the control access panel (Outer Door Assembly).

6. Turn the valve power switch to “OFF.”

7. Wait five minutes to clear out any gas. Then smell for gas, including near the floor.

If you smell gas, STOP! Follow “C” in the safety information. If you do not smell
gas, go to the next step.

8. Turn the valve power switch on to the valve.

9. Close the access panel (Outer Door Assembly).