AAA-055-00188
Jaylor Owner Manual
-43-
5000 Series Truck Mount Models
24.5.2 Greasing
Use
Section
to keep a record of all scheduled servicing. Unless specified otherwise, components
should have one pump of grease after every 16 loads or 50 hours. Use SAE multi-purpose high
temperature grease with extreme pressure (EP) characteristics on all areas requiring grease lubrication.
All Jaylor Truck Mount models are equipped with a driveshaft assembly that transmits power from the
truck engine to the hydrostatic pump drive system. Depending on the model and options specified,
grease locations will vary. Grease is required at each cross or ‘u’-joint found on the driveshaft. Grease
is also required on the telescopic tube assembly. Crosses and telescopic tube assemblies will require
1
pump every 16 hours and/or 50 loads
. Refer to the diagrams that follow for typical grease locations:
1. Wipe grease fitting clean before greasing, to avoid injecting dirt and grit.
2. Replace and repair broken fittings immediately.
3. If fittings will not take grease, replace immediately.
Figure 16 - Grease Location on Driveshaft
Figure 17 - Central Grease Decal for Tower Gearbox Lubrication
(Location Labeled in Figure 18)
* - Gearbox should be greased 1 pump every 8 hours or 25 loads
