AAA-055-00188
Jaylor Owner Manual
-28-
5000 Series Truck Mount Models
Cutting and Mixing Procedure
Follow this procedure when using the machine:
1. Review the Pre-Operation checklist, as described in
Section 13
2. Review the location and function of all controls, as described in
Section 15
3. Transport the machine to the feed storage area.
4. Always follow this procedure when
starting
the machine to minimize high startup loads:
a. Start the engine and run at low speed.
b. Engage the hydraulic pumps to start the auger.
c. Increase engine speed until the desired RPM is reached.
d. Proceed with loading of the ration.
5. Loading Feed Rations:
a. Position the mixer where the loading machine has clear and easy access.
b. Begin adding ingredients to the mixing chamber in order to cut and mix a uniform feed ration.
c. When adding ingredients, watch the numbers on the scale indicator to monitor the weight of
each ingredient as they are added.
d. Mixing time may vary depending on the ingredients being mixed. Typically, a total mixed
ration is achieved in 3 to 5 minutes beginning after the last ingredient is added.
6. Stopping:
a. Stop forward motion.
b. Close unloading door.
c. Stop conveyor when commodity is off.
d. Slow engine to low idle.
e. Disengage hydraulic pumps.
f.
Stop engine if required.
DANGER:
Never enter the mixing chamber or go on the conveyor unless all controls are in neutral,
engine stopped, park brake set, ignition key removed and all moving parts have stopped. Failure to
follow these safety precautions can result in serious injury or death.
IMPORTANT:
If an emergency should arise, turn hydraulics off, stop forward motion and stop
engine immediately
.
IMPORTANT:
Rapid engagement under a heavy load can cause damage. Engage slowly for the
best results.
IMPORTANT:
Always remove twine, string, and wrapping material from bales and/or other
commodities from the ground that will be loaded into the mixing chamber. Failure to follow these
requirements can cause damage to the machine.
