Javad TRIUMPH-1M, Руководство пользователя

Страница: 13 / 27

www.javad.com 13
TRIUMPH-2. If external power supply has only SAE
connector, Receiver-to-SAE power cable shall be
used. The external power supply needs to be Listed
for US and Certified for EU countries, it needs also to
be a Limited Power Source and have an output rated
for 10...16 V DC, 3A. This may not be the same range as
other JAVAD GNSS products with which you are famil-
iar. To avoid the introduction of hazards when oper-
ating and installing, before connecting of the equip-
ment to the supply, make sure that the supply meets
local and national safety ordinances and matches the
equipment’s voltage and current requirements.
Figure 5. Power supply / Charger
Warning:
Never attempt any maintenance or cleaning of the
supply while plugged in. Always remove supply from AC power
before attempting service or cleaning.
If the voltage supplied is below the minimum spec-
ification, the receiver will suspend operation. If the
voltage supplied is above the maximum specification,
the receiver may be permanently damaged, voiding
your warranty.
Make sure cords are located so that will not be
stepped on, tripped over, or otherwise subjected to
damage or stress. Do not operate equipment with a
damaged cord or plug – replace immediately. To re-
duce the risk of damage to the equipment, pull by the
plug body rather than the output cord when discon-
necting the equipment.
Warning:
Do not operate the supply if it has received a sharp
blow, been dropped, or otherwise damaged. Do not disassemble
the supply.
Before connecting the external power source and
the receiver, make sure that the power source match-
es the receiver’s voltage and current requirements.
POWERING THE RECEIVER
To check the status of the internal batteries, view
the BAT LED or check the status using JAVAD GNSS
software. Check the BAT LED for battery status.
To charge the receiver internal batteries, take the
following steps:
• Plug the Receiver-to-SAE cable’s connector into
the power port of the receiver (14-578125-01).
• Connect the opposite end of this cable with the
battery charger’-s SAE connector (22-570101-01).
• Plug the other end of this cable into an AC outlet
with cable (14-508053-01). Leave overnight.
SIM CARD SLOT
The SIM card slot allows a standard microSIM card
to be installed in the receiver. Once installed, the
SIM card provides a unique identification for the re-
ceiver’s GSM module and enables the receiver’s GSM
functionality based on the subscribed services (the
receiver board accesses the GSM module which ac-
cesses the SIM card). The SIM card usually remains
inside the receiver.
Note:
A SIM card can be purchased from your local cellular
provider.
Figure 6. SIM-card slot
DATA AND POWER PORTS
• Power –is used to connect the receiver to an ex-
ternal power source. This port can also be used to
charge the batteries.
• Serial – is used for communication between the
receiver and an external device.
• Ethernet - is used to connect the receiver to local
network.
• USB – is used for high-speed data transfer and
communication between the receiver and an ex-
ternal device.