Javad DELTA, Руководство оператора

Страница: 52 / 92

Setup and Measuring
Kinematic (Stop & Go) Measuring for Rover Stations
Measure Antenna Height
52
www.javad.com
same elevation mask angles. The length of the observation sessions can vary from a few minutes
to several hours. The optimal observation session length depends on the following factors:
• The length of the baseline measured
• The number of satellites in view
• The satellite geometry (DOP)
• The antenna’s location
• The ionospheric activity level
• The types of receivers used
• The accuracy requirements
• The necessity of resolving carrier phase ambiguities
Generally, single-frequency receivers are used for baselines whose lengths do not exceed 15
kilometers (9.32 miles). For baselines of 15 kilometers or greater, use dual-frequency receivers.
Dual-frequency receivers have two major benefits. First, dual frequency receivers can estimate
and remove almost all ionospheric effect from the code and carrier phase measurements,
providing much greater accuracy than single-frequency receivers over long baselines or during
ionospheric storms. Secondly, dual-frequency receivers need far less observation time to reach the
desired accuracy requirement.
After the measuring completes, data the receivers collect can be downloaded onto a computer and
processed using post-processing software (for example, JAVAD GNSS Justin).
4.4. Kinematic (Stop & Go) Measuring for Rover Stations
In a kinematic, stop and go measuring, the stationary receiver (Base station) is set up at a known
point such as a measuring monument, or an unknown point. The receiver continually tracks
satellites and logs raw data into its memory. The Rover receiver is set up at an unknown point and
collects data in static mode for 2 to 10 minutes. When finished, assign the Rover to kinematic
status and move to the next measuring point. At this point, and each subsequent point, the receiver
is changed to static mode to collect data. So, while moving, the Rover is in kinematic mode, and
while collecting data, the Rover is in static mode.
1. Set up the Rover at an unknown point and press power. Allow the Rover to collect static
data for two to ten minutes. The REC LED will be yellow.
2. Check the SAT light for satellites tracked.
3. When finished, press the FN button for less than 1 second to assign the Rover to
kinematic.