Jasic EVO 2.0 EM-160C, Руководство оператора

Страница: 19 / 82

19
CONTROL PANEL - JASIC MIG EM - 160C and EM - 200C
1. Remote control selection: Pressing this button will set current control from the panel to a remote
device such as a foot pedal, TIG torch remote potentiometer or a remote control device for MMA.
When in remote mode the LED indictor will also light up.
2. Synergic selector button: Turns synergic mode on or off. When in synergic mode the LED indictor will
also light up.
3. Wire inch switch: When pressing this button, the feed motor will activate and feed the welding wire
through the liner torch until it comes through the welding tip. When the wire is inching the LED
indictor will also light up.
4. Gas purge switch: When the gas - check button is pressed, the gas will flow. When the key is pressed
again gas flow will cease. When the gas is purging the LED indictor will also light up.
5. Welding process selection area and selector switch: Allows user to select MIG, MMA or Lift TIG.
6. Material and gas selection area, pressing either the up or down buttons will scroll you though the
preset material and gas combinations type selector button (preset according to material selected).
7. Top digital display with rotary encoder for carrying out parameter adjustments including wire feed
speed, current control and material thickness depending on welding process mode.
8. Bottom digital display with rotary encoder for carrying out parameter adjustments including voltage,
inductance/arc force and burn back time depending on welding process mode.
9. Warning indicators:
a. The yellow warning LED will light up if the machine overheats.
b. The red warning LED will illuminate if the machine experiences an input mains under or over
voltage situation.
c. The VRD indicator The VRD (Voltage Reduction Device) LED will be lit when the machine is in
MMA mode and the VRD function is enabled.
10. Standard MIG gun or Spool Gun switch: This selector button allows the use of a spool gun to be used
in MIG Mode, the selected LED indictor will also light up.
11. Torch trigger mode selection area: Use this selector button to choose between 2T or 4T mode for
MIG torch finger switch control, the selected LED indictor will also light up.
12. MIG wire size selection area: Here you can choose between various MIG wire sizes, pressing the
button will scroll you through the size options and is highlighted by the LED indicator lighting up.