Japan Radio Co. JUE-60GX, Инструкция по эксплуатации

Страница: 131 / 150

E-11 Appendix E Troubleshooting & FAQ
1
2
3
4
5
6
7
8
9
10
付録
B
付録
D
APP E
付録
M
付録
N
17
18
19
20
21
22
23
24
付録
A
26
27
28
E.6.1 LED blinking indication
Two LED lighting modes, normal mode and caution mode, are available. When an excessive impact is
detected, it switches to caution mode and indicates in real time by blinking faster at once the all LED of
STS1-4.
Please note the caution mode behavior is different before and after the accumulated-time-threshold
(ACC-th) is exceeded.
Before exceeding the ACC-th
- The LED lights in caution mode when it exceeds G-th and returns to normal mode when it falls
below G-th.
- Impact alarm is not recorded
After exceeding the ACC-th
- Impact alarm is recorded only once
- The LED will continue to light in caution mode even if it falls below G-th.
- Impact alarm continues until the accumulative counter is cleared
Impact
acceleration
[G]
clear counter
LED lighting mode
record alarm
Normal
N C N C N C
Caution
C N C N
impact
accumulated
time [min]
time
time
threshold
(G-th)
threshold
(ACC-th)
Impact indication （ 0.5 sec period red blink ）
STS2 STS3 STS4 ANT STS1 READY
RX2 STATUS
CM
PWR
TX RX1 NET
G R R R R
STS2 STS3 STS4 ANT STS1 READY
RX2 STATUS
CM
PWR
TX RX1 NET
G
Normal
R G G G
R G Green On
Undecided
R
LED lighting
STS2 STS3 STS4 ANT STS1 READY
RX2 STATUS
CM
PWR
TX RX1 NET
G R G G G
Red On
Red Blink
mode
change
Ex ： STS1 （ BDE ） alarm remaining case
Normal
Normal mode （ N ）
Caution mode （ C)
“Impact indication” and
“Normal” are repeated
every 5 seconds