39
39
7.25 CLERK CODES
It's possible to program on the ECR, until 9 "secrets" codes for clerks (the cashiers,
waiters...).
- Each code can be composed of max. 4 digits ; last digit of the code must be equal
to 1,or to 2,or to 3... or to 9 respectively for the clerks from 1 to 9.
- So the Clerks codes will have to be programmed and subsequently recalled in the
following way, before codes programming the previous codes memorized must be
reset by the "Z" report below described :
R (Clerk code) Clerk CODE key
KEY
max. 4 digits
Eg.: 2234 for the Clerk 4, 5772 for the Clerk 2, etc...
- The programmed Clerks codes can be deleted automatically after every daily full
terminal reset (Z--1--Tot.1), this depends from Status System 5F setting
- The Clerks' codes can in any case be cancelled independently from the Status
System 5F setting, by following "Z" report (following "Z" report will be possible only
after the daily full terminal reset "Z--1--Tot.1"):
Z (42) TOTAL 1 (Cash)
KEY
- In "Reg." mode, if the key "Clerk Code" will be directly pressed, the Clerk at the
moment active will be immediately inactive ; on the ECR's display it'll
appear "OP" and no operation of registration will be possible until a clerk code
input.
7.26
CLERKS NAMES : PROGRAMMING
to repeat for each clerk
P (2A) X/time (CCCCCC…..CCCC)
X/time ST #/NS
KEY
Up to
20
character code numbers
A
: from 1 to 9 depending from Clerk to program
CCC….CCCC : Clerk's name to program.
description to insert by using the ten keys(max
20
characters).
Note :
⇒
in order to cancel the last character input press the "E.C." key
⇒
to obtain double width characters it is necessary to press the key "," (decimal
point) before the characters to program
⇒
in order to obtain the small characters it is necessary to press the key "R.M.
" before the characters to program
⇒
the space corresponds to double zero key "00".
Содержание J3500E
Страница 55: ...49 49 ...