emVIEW-12T/D (
User's Manual
) Installation
3 - 9
Rev. 1.3
© Janz Tec AG
3
Installation
When opening the shipping package of the emVIEW-12T/D, the contents of the package should be
checked immediately.
The emVIEW-12T/D is delivered in a configured state, but the configurations can be adjusted by the
user as well. To adjust the emVIEW-12T/Ds configuration, an OSD (On Screen Display) is installed
and controllable by buttons at the backside.
The package also contains a terminal plug for the power connector. The emVIEW-12T/D needs a
power source in between 14 to 30V DC for operation.
The installation of this equipment is allowed for qualified service personnel, only.
Auxiliary existing rules for installation of electrical equipment must be attended to.
3.1
Dimensions and mounting information
figure 3: emVIEW-12T/D measures
The needed cut-out measures are given by
A
and
B
. The overall front panel dimensions are denoted
with C and D. E is the depth of the case.
A
B
C
D
E
300 -0/+2 mm
240 -0/+2 mm
320 mm
260 mm
42.5 mm
table 1: emVIEW-12T/D dimensions
C
D
B
A
E
A
