Installation
Box-Less Style (PNB)
1.
Mount phone on the car station.
2.
Attach red lens cap and bezel to ¼” hole on car station.
3.
Insert LED into lens cap and plug wire into P6.
4.
2 LED versions – Red LED goes to “Call in Progress” (P6)
Green LED goes to “Alarm Received” (P5)
5.
Attach emergency button leads to terminal block at P2 (EXT ON/OFF).
6.
Attach phone line to terminal block at P1 (TELCO) or the P1A modular
phone jack.
Box Style (PBX)
1.
Mount back box into phone cabinet on car station.
2.
Allow enough room at bottom for opening and removing phone cover.
3.
Attach phone line to terminal block at P1 (TELCO) or the P1A modular
phone jack.
4.
Attach phone cover with screws provided.
Flush Mount Style (PSS/PSL)
1.
Cut 5 x 9 inch hole for the phone.
2.
Using the plate as a template, mark and drill holes for the mounting
screws.
3.
Attach phone line to terminal block at P1 (TELCO) or the P1A modular
phone jack.
4.
Mount phone (screws not provided).
Surface Mount Style (PSM)
1.
Use mounting plate as a template.
2.
Attach mounting plate to wall.
3.
Attach phone line to terminal block at P1 (TELCO) or the P1A modular
phone jack.
4.
Attach phone cover with screws provided.
NOTE:
All style phones are phone line powered. If a battery is needed,
attach an 8.4V NiMH or a Standard 9V-Alkaline battery to the Battery Clips
on board (see Battery and Power Supply section for more information).
CAUTION:
To reduce or eliminate any possible interference, it is highly
recommended that the wiring used inside the traveling cable for the
incoming phone is 20-22 AWG twisted shielded pair with the shield
grounded at the elevator controller end only. Any terminations or splices
between the elevator controller and the elevator phone should have the
shield carried through the termination of splice and not grounded at that
point.
3
Содержание PBX
Страница 4: ...PC Board Diagram 4 ...
