22
5.4
Auto-Restart
If the Input Power Cord is connected to the wall receptacle properly and
Utility is back to normal, the UPS will automatically restart to provide energy to the
output after battery cut.
5.5
Alarm Silence
1.
The Alarm might be turned off by pressing the “On” Switch for
approximately 1 second in the “Backup” mode.
2.
Unless any other warning or fault condition occurs, the alarm remains at
Silence condition once the “Alarm Silence” is turned off.
5.6
Self Test
1.
Under Utility Normal condition, press the “On” Switch for 3 seconds to
execute the Battery Self-test function.
2.
In case the battery is normal, it will enter into the Battery Backup Mode for
10 seconds then return to Utility Mode.
3.
If the battery voltage is detected lower than set limit, the Battery
Replacement
LCD
will blink for 5 seconds then extinguish to stop self-
test procedure. And if battery is detected weak or dead, the Battery
Replacement
LCD
will steadily illuminate.
Caution---
The UPS will remain at “NO” output, if the start-up operation is not
proceeded properly even though the Input Power Cord is connected
to the wall receptacle.
Important Notice---
Plug the UPS onto the wall receptacle to charge the UPS for over 8
hours after initial installation.
Storage ---
Store at -15 to +30 °C (+5 to +86 °F), charge the UPS battery every six
months.
Store at +30 to +45 °C (+86 to +113 °F), charge the UPS battery every
three months
23
6
UPS MAINTENANCE
6.1
Battery Replacement
When the UPS is started up or a self-test is executed, the Battery
Replacement LED might light up due to battery weak or battery dead.
1. When the Battery-Replacement (RED) lights up, you may leave the UPS to
be re-charged for at least 8 ~ 10 hours to see whether the RED LED will be
extinguished after the Self-test function is executed again.
2. In case the RED LED remains unchanged, you may unscrew the Easy
Swappable Battery cover, replace a new battery then push the “On” Switch
to disable the RED LED. Please follow the steps 1-3 to replace the new
battery.
Caution---
The UPS will remain at “NO” output, if the start-up operation is not
proceeded properly even though the Input Power Cord is connected
to the wall receptacle.
Caution---
The battery is heavy, pull the battery out onto flat, stable surface.
Caution---
DO NOT DISCONNECT the batteries while the UPS is in the BACKUP
mode.
