TIGER
BELT-SANDER FOR WOODEN FLOORS
ED 95
PG.
7/16
INSTRUCTION MANUAL
INSTRUCTIONS FOR ELECTRICAL CONNECTION
CAUTION:
This machine only works with the voltage and frequency shown on the
machine plate. Before connecting the cable to the power supply grid,
make sure that the voltage and frequency available are correct.
DANGER:
Exposing the machine to water or rain leads to a risk of electrocution.
Keep the machine in a dry building.
DANGER:
Incorrect mains connection of the machine leads to a risk of
electrocution. In order to prevent possible electric shocks, always use a
three-wire electric system connected to an electrical earth. For
maximum protection against electric shocks, use a circuit protected
with a differential earth fault interrupter.
DANGER:
Tampering with the earth pin in any way may lead to electrocution. Do
not cut, remove or break the earth pin. Do not try to insert a three-pin
plug into a socket or connector which does not have three holes. If the
plug does not fit the socket, consult an authorized electrician.
DANGER:
Using the machine with a damaged plug or power supply cable may
lead to electrocution. If the cables or plugs are worn or damaged in any
way, have them replaced by an electrician or authorized service staff.
CABLES, EXTENSIONS AND PLUGS
Only use approved three-wire cables, two of which are current-carrying and one earth.
The maximum recommended length of the cable is 10 m; for lengths of greater than 10 m use cables
with larger cross- section.
DANGER
If the machine is used with cables of insufficient cross-section and/or
excessive length, damage to persons and/or things may occur.
For Europe, the power supply cable must be of the HAR approved type, namely HO5VV-3x2.5 mm2,
and the plug must be of the 2P+T16A-250V approved type.
For non-European versions, consult an authorized JANSER distributor.
